Ceiling Fan Remote Not Working Troubleshooting

If the ceiling fan and light works normally then the remote control module will need to be replaced.

Ceiling fan remote not working troubleshooting.

There are some steps to try troubleshooting the remote. Remotes can stop working for a variety of reasons. If you are using a remote or. Check the batteries in your ceiling fan s remote.

The solution is to press the fan high button and then light on on the remote control unit and then pull the pull chains until the light comes on and the fan runs on high. The easiest way to find a replacement remote with all the settings that your existing remote offered is to shop by brand. If you have an older ceiling fan the switch may be worn out. The dip switches need to match each other in order for them to be on the same frequency and work properly.

Below are troubleshooting steps to follow. Yes the ceiling fan remote control module may be faulty. To start troubleshooting the dip switches on the fan you need to try changing the position of the dip switches. In terms of troubleshooting hunter ceiling fan remote controls much of the troubleshooting will be similar to troubleshooting other fans.

Check to ensure that the problem is not with the remote see fanimation remote not working guide above if the mains supply circuit. One way to know for sure would be to remove the receiver module at the ceiling fan and wire it direct. Here s how to troubleshoot a remote control that isn t working. Locate the receiver for the remote usually housed in your fan s mounting bracket and find the.

In this case replace the reverse switch. There would be dipswitches on in the back of the remote as well as on or in the fan canopy. Flip the switch several times to make sure it is the right. Troubleshooting a remote is a more common issue as it applies to most ceiling fans not just harbor breeze ceiling fans.

The troubleshooting to try is common as it applies to different fans. Make sure that the power is turned on to the fan. Try using the remote to turn on the. First ensure that the mains power is turned on and then check to ensure that the circuit breaker for the unit is not.

Turn the power off to the fan at the circuit breaker box. This may seem like a rudimentary or obvious thing and yes we do start. Assuming you don t have another ceiling fan and remote to test your troublesome fan with and the remote just suddenly stopped working you may want to consider replacing both the remote and the receiver.