1 the good thing is that you can dig all the post holes at once.
Chain link fence instructions.
For aesthetic reasons space posts evenly but do not exceed ten feet between posts.
As chain link fence posts are smaller and sturdier than many other types the holes should be smaller and can be farther apart.
11 steps of chain link fence installation step 1.
There may be local zoning or deed restrictions pertaining to height and type of fence.
Check all the regulations about fence setbacks type and height.
Also be sure to determine the property boundary and the local setback rules.
Obtain necessary zoning and building permits.
Mark the fence location.
Step 2 with crayon or chalk mark the ground line on posts.
Chain link fence installation manual before you begin.
Locate your property s line.
This will help avoid encroaching on adjoining property with concrete footings.
Most fence installers recommend that all posts be set approximately 4 inside the property line.
The exact diameter and depth will be determined by local weather and soil conditions.
Once you have determined the property line and legal setback mark out the location of the fence.
If you plan on installing privacy slats or another type of material that will increase wind load consider using 8 or 6 post spacing.
This is easily done by stretching a string along the property line and setting the posts 4 inside.
Put hinges and latch hardware onto the gate posts at roughly their final positions to install later.
Check out your property line setback requirements.
Follow the fence manufacturer s instructions for spacing which typically ranges from 4 10 apart spacing should not exceed 10 on center.
All posts should be set about 4 inches inside the line.
Mark the fence location before you start have the local utility company mark all underground utility lines.
The key point to remember with chain link fencing is that in order to achieve a rigid strong fence your posts must be concreted in line wire needs to be tensioned along the fence line and the chain link must be tensioned and secured correctly to the posts and line wire.
If using fast set concrete pour the dry mix around each post to a few inches below ground level and add water.
Slide tension bands onto each corner gate and end post.
The bands will help hold the mesh in place once it s installed.
Initially the water will sit on top but eventually will work its way to the bottom.
Leave the concrete a few inches below ground level.
Chain link fence gate installation instructions figure 2 figure 3 figure 4 step 1 dig terminal post holes approximately 8 in diameter and 30 deep with sloping sides fig.
Slope it away from the post to help with water runoff.
